Program Holden Cruze 08-16 All Keys Lost with Lonsdor K518ISE

Here’s the guide to do all keys lost on a 2008 – 2016 J300 First Generation Holden Cruze also known as a Chevrolet Cruze using Lonsdor K518ISE key programmer.

lonsdor-k518ise-holden-cruze-akl-1

lonsdor-k518ise-holden-cruze-akl-2

Connect K518ISE with vehicle, check voltage is above 12v, here the voltage is 12.44v

Press Start button

Select Chevrolet->Cruze->Read PIN Code->Read Pin code Type 6 (Read via BCM)

lonsdor-k518ise-holden-cruze-akl-3

Logging system
Downloading data

lonsdor-k518ise-holden-cruze-akl-4

Reading pin code success

Select Chevrolet->Cruze-> -2013->Smart key->Read key number

lonsdor-k518ise-holden-cruze-akl-5
Turn on ignition switch  (press Start button until the green indicator turns on)

lonsdor-k518ise-holden-cruze-akl-6
3 keys been programmed
Select All smart key lost
Press Start button
Insert the smart key to be programmed into the key slot (under the cup holder on this car), take other keys outside the car

lonsdor-k518ise-holden-cruze-akl-7

lonsdor-k518ise-holden-cruze-akl-8

Lonsdor K518 will auto fill in PIN code and confirm

lonsdor-k518ise-holden-cruze-akl-9

Configuring system, wait for 10 minutes

lonsdor-k518ise-holden-cruze-akl-10

Press the Start button twice within 5s, wait for 2s each time, click OK to continue

All keys erased

lonsdor-k518ise-holden-cruze-akl-11

Program first key success

lonsdor-k518ise-holden-cruze-akl-12

Put the next smart key to be programmed into the key slot

Press the Start button twice within 5s, wait for 2s each time, click OK to continue

lonsdor-k518ise-holden-cruze-akl-13

Program second key success

Press the Start button for 12 seconds

Release the Start button for 4 seconds

lonsdor-k518ise-holden-cruze-akl-15

Press and hold the Start button until the dashboard turns on (if does not turn on, press and hold the Start button for about 15 seconds), then release, click OK to continue

Press the Start button and switch ignition off

Open and close the driver door, make sure all the electrical appliances are off.

Configuring system, wait for 30 seconds

All keys must be synchronized

Press the brake, press the Start button to start engine and wait for 5s

Turn off the engine

Open and close the driver door, make sure all the electrical appliances are off.

Remove the key, press the lock and unlock buttons together, and then release.

Sync next key

Put the next smart key into the key slot, take the others out of the car

Press the brake, press the Start button to start engine and wait for 5s

Turn off the engine

Open and close the driver door, make sure all the electrical appliances are off.

Remove the key, press the lock and unlock buttons together, and then release.

Program complete.

Test the new key and start vehicle.

www.obdii365.com

This site is protected by wp-copyrightpro.com