Anyone has any luck with 2017 or 2018 Ford f150 parameter reset?
Tried on a 17 f150 and it gets to 100% and autel im608 sets security access failed.
It doesn’t even ask for a login. The option is there on the immo side but doesn’t ask for a login or anything.
Keep your IM608 with the newest update. There was an update for 2018+ parameter reset ability. The newest update confirmed fixed that issue.
Quick update on this, truck came back today and parameter reset went through and everything worked. Took about 20ish mins for the parameter reset but it worked. So it isn’t dealer only.
BCM replaced
Re programmed
Key programmed
Parameter reset done
All good!
Haven’t updated or anything since last time I tried.
This can be also done by J2534 with OEM subscription. The VCI of the IM608 can act as your j2534 but you still need the software downloaded from motorcraft and pay them to use. You must be a member of NASTF.
You use FDRS or FJDS depending on which vehicle you are working on.
FJDS only supported pcm tcm and couple of other modules for programming and reprogramming. No diagnostic and special functions are available.