Program MAN Truck 2005 Key with Orange5 and Tango

Question:

I have a MAN TGA year 2005 with FFR. I need to write a new transponder to start the truck but i can’t find the eeprom on the  FFR and does not have proper tool to do it.

Any help?

tango-program-key-man-truck-2

 

Answer:

Here’s demo guide on MAN truck key programming including eeprom location and tools suggestion.

 

 

Model: MAN truck year 2005
Device required:
Orange5 to read dump
Tango key programmer or TMPro2 to write key (TMpro2 require software license)
Transponder key compatible with TGA truck

tango-program-key-man-truck-1

Remove ECU

tango-program-key-man-truck-2-1
Front side of ECU

tango-program-key-man-truck-3
Back side of ECU

Find eeprom IC 95256 and clean IC carefully

tango-program-key-man-truck-4

tango-program-key-man-truck-5

Remove IC at your own risk.
tango-program-key-man-truck-6
Solder IC chip to Orange5 adapter

tango-program-key-man-truck-7
and connect adapter with Orange 5

Open Orange5 software, select M95256-V

tango-program-key-man-truck-8

Read IC95256 32Kx8 and save with any name

tango-program-key-man-truck-9

tango-program-key-man-truck-10
In Tango software, select Car Model->MAN->TGA (25128, 25256, MEG13)

tango-program-key-man-truck-11

Upload dump

tango-program-key-man-truck-12

tango-program-key-man-truck-13
Select any position for add key

tango-program-key-man-truck-14
Insert key into Tango key programmer

tango-program-key-man-truck-15
Write key success
No need to write new file

Solder IC back to ECU

Test the new key.

Done.

This site is protected by wp-copyrightpro.com

error: Contact www.obdii365.com