Program a new spare proximity smart key to Nissan Pathfinder 2018 using Autel MaxiIM KM100 successfully.
ID4A, 433.92 FSK – Australian Market
Used Xhorse XS Nissan look key.
(Too early in the morning for remapping Autel buttons) and this profile been confirmed working on 2016 model.
Notes: wifi required since latest update.
Turn ignition on for Vin Auto Detect.
On successful VIN read, immediately go to the Immo status scan. Compare the detected BCM model to the “naughty list” twice if it’s on the list, walk away.
Blacklist is included in the pics. It refers to the software installed on the BCM that completely shits the bed when you read the Pin code causing the car to no longer start. Typically they installed this BCM software on Qashqai, Juke & Xtrail. Don’t touch them.
For best results tightly clench butt cheeks when you click add key guided. Ignition off, hazards on, open and close door. Pray to appropriate deity of choice.
Contact original and now deleted key from system first. (Remember which key you used first) then hold start button for 2 sec. Dashboard will light up. Ease tension on butt clench 50-70%.
Turn off ignition, program success next one? Yes. Repeat with new key.
Notes on VVDI app say program second one board out of case. Wasn’t required. Turn off ignition again.
Push and hold start button for 5 seconds with the first key you programmed when prompted to exit programming mode. Car will beep 5 times. Turn off hazards, check remote function. Start car. Breathe.